Fixing “STOP:0x00000050 ” Error Message In Windows 7 And 2008 Article

	1888 Articles Home \| Computer Articles \| Data Recovery Articles \| Windows Articles	Data Recovery RSS
Fixing “STOP:0x00000050 ” Error Message in Windows 7 and 2008

Commonly known as STOP errors, BSOD (Blue Screen Of Death), and Blue Screen of Doom, these error messages can be a cause of worry for any Windows computer user. A STOP error message appears when the system encounters some critical problem, caused primarily due to poorly-written device drivers and hardware malfunctioning.

Author: Jacob Luis

Article Tools:

Since, a STOP error message appears at the time of booting, it results in inaccessibility of files saved in a hard drive. In such cases, the user needs to follow the traditional approach of restoring the data from an updated backup. But, with inaccessibility of data backup or the user only having a partial backup, it becomes necessary to use an advanced Data Recovery Software to recover the data.

To elaborate the above case, consider a practical case where you either have a Windows 7 or 2008 based system. You install a new third-party software which uses WFP (Windows Filtering Platform) callout driver. However, after the installation process is completed and you attempt to boot your system, you encounter the below STOP error message:

“STOP: 0x00000050 (parameter1, parameter2, parameter3, parameter4)

PAGE_FAULT_IN_NONPAGED_AREA”

The four parameters listed in the above STOP error message differ with the configuration of your system.

Inaccessibility of data is one of the major hazard that you encounter after the above error message appears on the software.

Cause:

The main reason liable for the above STOP error message is an error in TCPIP.sys system driver. The moment the WFP callout drive executes the FwpsReleaseClassifyHandle0 function in order to free few computer system resources, the error message appears.

Resolution:

To resolve the above error message and to access the data post the above STOP error message, you will need to make changes in the Windows registry. While modifying registry is an easy task, it can be dangerous if you perform some wrong changes in the registry. This will increase your problem manifolds and leave you with no option, but to format your hard drive. To perform Data Recovery from a formatted hard drive, you will need to search for advanced Data Recovery Software.

Stellar Phoenix Windows Data Recovery carries out maximum recovery of data by using advanced scanning procedures. The data recovery tools is compatible with FAT12, FAT16, FAT32, VFAT , NTFS and NTFS5 file systems and supports Windows 7, Vista, XP, 2003, and 2000 operating systems.

About Author

Jacob Luis is a student of Mass Communication and doing research on ntfs data recovery. He is also a file recovery software http://www.stellarinfo.com/file-recovery.htm specialist.

Article Source: http://www.1888articles.com/author-jacob-luis-24580.html

Fixing “STOP:0x00000050 ” Error Message in Windows 7 and 2008